RIP Quiz (Online) - Networkwalks Academy

1. Which Layer4 port is used by RIP for updates?

TCP port 520

UDP port 520

UDP port 250

TCP port 250

2. Three of the networks have approximately 50 hosts each and one network has 10 hosts. The multi-vendor Routers are connected by serial links that use separate subnetwork numbers. The ATech network has leased one Class C address to be used for all networks and serial links and they do not wish to replace any of their existing Routers. Which Routing protocol would be most appropriate for this scenario?

TCP/IP

RIP v1

RIP v2

EIGRP

3. What is route poisoning in RIP?:

It is information received from a Router that can’t be sent back to the originating Router

It sends back the protocol received from a router as a poison pill, which stops the regular updates

It prevents regular update messages from reinstating a route that has just come up

It describes when a router sets the metric for a down link to infinity

4. Which of the following is true regarding RIPv2?

It has a lower administrative distance than RIPv1

It has the same timers as RIPv1

It converges faster than RIPv1

It is harder to configure than RIPv1

5. Can subnet mask information be stored in a RIPv1 packet?

yes

NW Network uses RIP as the Routing Protocol. This RIP network has been fully operational for two days. Each routing table is complete. Which networks will be included in the next routing update from the nw_R1 to the nw_R3?

A, B, C, D, E, F

B, D

A, C

A, B, C

A, B, C, D

D, E, F

7. RIP decides the best path (routing metric) based on what?

MTU

Hop Count

Delay

Bandwidth

8. Where should we use Default Routing?:

On networks which minimum 5 exit paths out of the network

On stub networks (which have only one exit path out of the network)

On networks which have more than one exit path out of the network

None of the above

9. Which protocol gives a full route table update every 30 seconds?

IEGRP

RIP

None of the mentioned

Both IEGRPand RIP

10. What is the maximum number of route entries in a RIPv1 update?