EIGRP Quiz (Online) - Networkwalks Academy

Please enter your email:

Which type of Routing Protocol is EIGRP?

Advanced Path Vector

Link State

Advanced Distance Vector

EGP

Two Routers R1 and HG are configured for EIGRP as in below. Unfortunately, users on the R1 networks are unable to reach users on the HG networks. Which command could you enter to correct this problem on the shown ATech Network:

eigrp-question-3

Router (config-router)# version 2

Router (config-router)# no auto-summary

Router (config-router)# EIGRP log-neighbor-changes

Router (config-router)# default-information originate

Router (config-router)# redistribute EIGRP 44

What is the Administrative Distance for internal EIGRP?

110

170

In EIGRP, best path is known as the Successor. What is the backup path known as?

Feasible successor

There is no backup route in EIGRP

Default route

Back-up route

EIGRP is a routing Protocol designed by Cisco which cannot operate on Juniper Routers?

TRUE

FALSE

Which features does EIGRP support?

Unequal cast load balancing

All the above

VLSM/subnetting

Auto summary

There are two Routers A and B in enterprise network of a company named as NETWORK WALKS, that use EIGRP. How does Router A watch for the status of Router B so that router A could react if router B fails?

Using a periodic ping of B’s IP address based on the EIGRP neighbor timer

None of the other answers are correct

By using EIGRP update messages, with A needing to receive periodic update messages to believe B is still working

By using EIGRP Hello messages, with A needing to receive periodic Hello messages to believe B is still working

What is the Administrative Distance for External EIGRP Routes?

110

170

100

Where are the EIGRP successor routes stored?

In the neighbor table only

In the topology table only

In the routing table only

In the routing table and the topology table

What is the solution to bring EIGRP up between these two company branches

eigrp-question-2

Execute the auto-summary command on both Routers

Execute the no auto-summary command on both Routers

Change the network on F0/0 of Router A to 192.168.3.0/24 and change the network on F0/0 of Router B to 192.168.2.0/24

Change the network on F0/0 of Router B to 192.168.1.48/28