Computer Networking Final Exam

Computers, Laptops and Servers are which type of Network Devices?

 An IP Address comprises of how many bits?

What is the AD (Admin Distance) of directly Connected Routes?

Which type of frame is this?

Which of below is a VLAN Tagging method and it can be used on Huawei/Juniper Routers (Open Standard)?

Which Transport Layer port is used by Telnet?

Which path will be chosen by R1 for traffic of R2? (i.e. which route will have the highest preference in R1’s Routing Table?)

HTTP belongs to which layer in OSI Model?

Which protocol used for IP Address Management?

Which type of Optical fiber is this one?

Which type of cable should you use when you are new to Cisco Packet Tracer?

Which one of the below is a valid IP Address?

What is the range of Normal VLANs?

Which path will be chosen by R1 for traffic of R2? (i.e. which route will have the highest preference in R1’s Routing Table?)

Switches are usually cheap devices while Routers are usually costly:

If we reset a Cisco Router, which value will never change?

Path selection & routing is controlled manually by the network admin in Static Routing:

On which layer of OSI Model does a Switch operate?

 Access Ports belong to only one VLAN

What is the use of VLAN (Virtual Local Area Networks)?

Can we run two IGP Routing Protocols inside one ISP Network (for example, in Vodafone or MTN)?

What is the AD (Admin Distance) of Static Routes?

What will be the default action of this Router when it receives an IP Packet from C with destination address as E? (E is not in its Routing Table)

Which Networking Protocol is used for communication between web Clients/browsers and web Servers?

If the destination MAC is unknown for a Frame, what is the default action of a Layer2 Switch?

What is the maximum length of an original Ethernet-II frame?

Which Transport Layer port is used by HTTPS?

What is the rate of Fast Ethernet?

Which protocol is more secure but slow?

Which command is used on Cisco Routers to query the Routing table?

Which Networking device is used to connect multiple hosts together (end devices) to create a Network?

Which command is used on Cisco Switches to query the MAC Address table entries?

A static route with 0.0.0.0/0 as the destination IP address (a route that matches all packets) is called:

Which ones of below are simulation Software that we can use for CCNA practice? (Choose two)

How an IP address is represented in networking usually?

Which of the following is true about Ethernet Crossover cables?

Which type of Layer-2 switch is this?

Which path will be chosen by R1 for traffic of R2? (i.e. which route will have the highest preference in R1’s Routing Table?)

IP Address is mainly used for Logical identification or Physical identification of a device in Networks?

Which type of cable has been used between Switch-1 and PC-B ?

IP Address of a device can be changed or not?

We can use Cisco Packet Tracer to configure IP address & Gateway on PC’s:

Physical Port to MAC address relation is shown in which table?

Which of the following is a VLAN tagging method for trunk links?

What is the length of VLAN Tag?

Which two methods can be used to configure Cisco devices in Packet Tracer simulation software?

MAC Addresses belong to which layer of OSI Model?

Two most important protocols at Transport Layer are:

Which type of link is this? (which has been highlighted in RED)

Which type of Routing is Less resource-intensive & less BW intensive?