CCNA Final Internal Exam 200-301 (Part-1-3)

Refer to the exhibit. An administrator must turn off the Cisco Discovery Protocol on the port configured with address last usable address in the 10.0.0.0/30 subnet. Which command set meets the requirement?

Refer to the exhibit. Which type of route does R1 use to reach host 10.10.13.10/32?

Which component of an Ethernet frame is used to notify a host that traffic is coming?

If a notice-level messaging is sent to a syslog server, which event has occurred?

Which command prevents passwords from being stored in the configuration as plaintext on a router or switch?

Which API is used in controller-based architectures to interact with edge devices?

Which technology can prevent client devices from arbitrarily connecting to the network without state remediation?

Which keyword in a NAT configuration enables the use of one outside IP address for multiple inside hosts?

What is the default behavior of a Layer 2 switch when a frame with an unknown destination MAC address is received?

Which implementation provides the strongest encryption combination for the wireless environment?

Router R1 must send all traffic without a matching routing-table entry to 192.168.1.1. Which configuration accomplishes this task?

Refer to the exhibit. An engineer configured NAT translations and has verified that the configuration is correct. Which IP address is the source IP?

Refer to Exhibit. Which action do the switches take on the trunk link?

Refer to the exhibit. Router R1 is configured with static NAT. Addressing on the router and the web server are correctly configured, but there is no connectivity between the web server and users on the Internet. What is a possible reason for this lack of connectivity?

Two switches are connected and using Cisco Dynamic Trunking Protocol SW1 is set to Dynamic Desirable. What is the result of this configuration?

Refer to the exhibit. When running EIGRP, what is required for RouterA to exchange routing updates with RouterC?

Refer to the exhibit. If OSPF is running on this network, how does Router 2 handle traffic from Site B to 10.10.13.128/25 at Site A?

Which of the following is the JSON encoding of a dictionary or hash?

Refer to the exhibit. Which address and mask combination represents a summary of the routes learned by EIGRP?

Which technique can you use to route IPv6 traffic over an IPv4 infrastructure?

A packet is destined for 10.10.1.22. Which static route does the router choose to forward the packet?

Refer to the exhibit. An engineer booted a new switch and applied this configuration via the console port. Which additional configuration must be applied to allow administrators to authenticate directly to enable privilege mode via Telnet using a local username and password?

Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?

Which protocol does an access point use to draw power from a connected switch?

Refer to the exhibit. Which switch in this configuration will be elected as the root bridge?

Which 802.11 frame type is association response?

Which type of ipv6 address is publicly routable in the same way as ipv4 public addresses?

Which type of wireless encryption is used for WPA2 in pre-shared key mode?

Refer to the exhibit. Which command would you use to configure a static route on Router1 to network 192.168.202.0/24 with a nondefault administrative distance?

AAA stands for authentication, authorization, and accounting

Which command enables a router to become a DHCP client?

Refer to exhibit.What Administrative distance has route to 192.168.10.1?

Which unified access point mode continues to serve wireless clients after losing connectivity to the Cisco Wireless LAN Controller?

Refer to the exhibit. Which password must an engineer use to enter the enable mode?

Which protocol prompts the Wireless LAN Controller to generate its own local web administration SSL certificate for GUI access?

Refer to the exhibit. Which prefix does Router 1 use for traffic to Host A?

What is an advantage of Cisco DNA Center versus traditional campus device management?

An engineer needs to configure LLDP to send the port description time length value (TLV). What command sequence must be implemented?

Which command on a port enters the forwarding state immediately when a PC is connected to it?

With REST API, which standard HTTP header tells a server which media type is expected by the client?

Which network plane is centralized and manages routing decisions?

R1 has learned route 10.10.10.0/24 via numerous routing protocols. Which route is installed?

Which command is used to display the collection of OSPF link states?

Which output displays a JSON data representation?

Which spanning-tree enhancement avoids the learning and listening states and immediately places ports in the forwarding state?

Which configuration ensures that the switch is always the root for VLAN 750?

Refer to the exhibit. After you apply the given configuration to a router, the DHCP clients behind the device connot communicate with hosts outside of their subnet. Which action is most likely to correct the problem?

Refer to the exhibit. What is the effect of this configuration?

Refer to the exhibit. When PC 1 sends a packet to PC2, the packet has. Which source and destination IP address when it arrives at interface Gi0/0 on router R2?

Refer to the exhibit. What is the effect of this configuration?