EIGRP Quiz (Online) - Networkwalks Academy

EIGRP is a routing Protocol designed by Cisco which cannot operate on Juniper Routers?

TRUE

FALSE

Which type of Routing Protocol is EIGRP?

Link State

Advanced Path Vector

EGP

Advanced Distance Vector

Which algorithm is used by EIGRP for finding shortest path?

SPF

Dijkstra algorithm

DUAL

Link state

EIGRP sends Hello Message after every ___________ seconds

5 seconds (LAN), 60 seconds (WAN)

15 seconds

180 seconds

5 seconds (LAN), 5 seconds (WAN)

There are two Routers A and B in enterprise network of a company named as NETWORK WALKS, that use EIGRP. How does Router A watch for the status of Router B so that router A could react if router B fails?

By using EIGRP update messages, with A needing to receive periodic update messages to believe B is still working

By using EIGRP Hello messages, with A needing to receive periodic Hello messages to believe B is still working

None of the other answers are correct

Using a periodic ping of B’s IP address based on the EIGRP neighbor timer

What is the solution to bring EIGRP up between these two company branches

Change the network on F0/0 of Router B to 192.168.1.48/28

Change the network on F0/0 of Router A to 192.168.3.0/24 and change the network on F0/0 of Router B to 192.168.2.0/24

Execute the auto-summary command on both Routers

Execute the no auto-summary command on both Routers

7. Router 1 and Router 3 do not seem to be exchanging information. You execute commands on all three routers and receive as output the information shown below. What needs to be done to make Routers 1 and 3 start exchanging information?

Recreate the EIGRP configuration on Router 3 as EIGRP 55

Execute the auto-summary command on Router 1

strong>Correct the IP address on the S1 interface of Router 3

Execute the network 192.168.9.0 command under EIGRP 56 on Router 3

Which of the following is the EIGRP Metric?

MTU

All of the above

Bandwidth

Delay

Two Routers R1 and HG are configured for EIGRP as in below. Unfortunately, users on the R1 networks are unable to reach users on the HG networks. Which command could you enter to correct this problem on the shown ATech Network:

Router (config-router)# redistribute EIGRP 44

Router (config-router)# EIGRP log-neighbor-changes

Router (config-router)# version 2

Router (config-router)# default-information originate

Router (config-router)# no auto-summary

10.

EIGRP supports Equal and Unequal Cost Load Balancing

TRUE

FALSE