EtherChannel Quiz (ENCOR, CCNP)

1. When a range of ports is being configured for EtherChannel, which mode will configure PAgP so that it initiates the EtherChannel negotiation?

2. What is a best practice to use before beginning an EtherChannel implementation?

3. EtherChannel can also be used for VLAN creations:

4. EtherChannel is also called as PortChannel:

5. A trunk link between two switches has reached its capacity. How can this be addressed in the most economical way?

6. Which ones are valid load balancing methods of EtherChannel technology?

7. Is there any EtherChannel in this topology or not?

8. Which one of below is an advantage of using EtherChannel technology?

9. Which statement describes a characteristic of EtherChannel?

10. Which of these is a link aggregation protocol?

11. Which Cisco command must be used on SW2 to enable an EtherChannel, if a network administrator is configuring an EtherChannel link between switches SW1 and SW2, by using the command SW1(config-if-range)# channel-group 1 mode passive?

12. Which Cisco command can be used to enter into EtherChannel interface configuration mode?

13. Which EtherChannel mode has been used in this configuration?

14. Which statement is true about EtherChannel?

15. Can we use LACP on one side of the EtherChannel link and PAgP on the other side?

16. Which statement is true regarding the use of PAgP to create EtherChannels?

17. What is an advantage of using LACP?

18. Which PAgP mode combination will establish an EtherChannel?

19. Which mode will configure LACP in a way that it will initiate the EtherChannel negotiation?

20. Which settings must match on both sides of the switch ports to form an EtherChannel?